TOPDON TB6000 Pro Charger | Evolve AutoTech — Sydney
Home / Shop / TOPDON TB6000 Pro
Shop · Battery Chargers

One tool that charges, tests and revives your battery.

The TOPDON TB6000 Pro is a 2-in-1 smart 6-amp charger and battery tester. Patented 9-step charging, pulse desulfation and full app control — built for both weekend DIYers and working technicians.

$160.00 AUD · inc. GST + shipping · ships Australia-wide
6V / 12V Lead-Acid & Lithium App Control via Bluetooth IP65 Rated
TOPDON TB6000 Pro smart battery charger and tester
topdon-tb6000.png
2-in-1
Charger and tester in a single unit
9-Step
Patented smart charging cycle
5–240Ah
Battery capacity supported
IP65
Dust- and water-resistant housing
Charge & Diagnose

Two jobs, one tool.

The TB6000 Pro charges 6V and 12V lead-acid batteries plus 12V lithium — and doubles as a proper battery tester. Using the Kelvin four-point method, it reads state of charge, state of health and cold-cranking amps, so you know whether a battery is worth keeping before you spend hours charging it.

  • Charges 6V/12V lead-acid and 12V lithium batteries
  • Tests SOC, SOH and CCA via the Kelvin method
  • Charging and cranking tests for 12V lead-acid
  • No need to carry a separate charger and tester
SOC · SOH · CCA
Full battery diagnostics
Smart Charging Report

See exactly what the charge did.

In smart charging mode the unit runs a health check the moment you connect, then lets you re-test afterwards. The before-and-after report compares voltage, internal resistance, CCA and state of health side by side, so the improvement is measurable rather than guesswork. Reports save to your phone as images for your records.

  • Automatic pre-charge battery health check
  • Before/after comparison of key battery readings
  • Save reports as photos to review any time
Before → After
Measured improvement
Recover & Maintain

Brings tired batteries back to life.

Using pulse-width modulation, the TB6000 Pro breaks down the sulfate build-up that chokes an ageing battery, restoring internal resistance and extending its working life. Leave it connected and it switches to maintenance mode — keeping seasonal, classic or weekend vehicles topped up and ready without overcharging.

  • Pulse desulfation to recover ageing lead-acid batteries
  • Maintainer mode for vehicles in storage
  • Dedicated smart charging mode for lithium batteries
PWM
Pulse desulfation
Restores resistance · prolongs life
App & Expert Control

Run it from your phone.

Pair over Bluetooth with the free TOPDON BatteryLab app (iOS and Android) to monitor charging live, generate reports and schedule sessions like setting an alarm — handy for charging on off-peak power. Technicians can switch to expert mode to fine-tune voltage, current, pulse current and duration across all nine steps, with live waveforms of the charge.

  • Beginner mode: pick a profile, tap start, walk away
  • Expert mode: tune each step and view live waveforms
  • Timed / scheduled charging for off-peak rates
  • Review past charge & test reports for up to 6 months
BatteryLab
iOS & Android app
How It Charges

The patented 9-step cycle.

Rather than dumping a flat current, the TB6000 Pro analyses the battery and works through nine stages — diagnosing, reviving and then maintaining it for a safer, longer-lasting charge on lead-acid batteries.

01
Diagnosis
Checks the battery's condition before any current flows.
02
Desulphation
Pulses break down sulfate build-up on the plates.
03
Pre-Charge
Gently wakes a deeply discharged battery.
04
Soft Start
Eases current up to protect the battery.
05
Bulk Charge
Delivers the main charge at full rate.
06
Absorption
Tops up the final capacity at a held voltage.
07
Analysis
Confirms the battery is holding charge.
08
Recondition
Restores capacity in worn batteries.
09
Maintenance
Holds a safe float charge for long-term care.
Wide Compatibility

One charger for the whole shed.

From the daily driver to the boat, the ride-on mower and the project bike, the TB6000 Pro covers the lot — handling capacities from 5Ah right up to 240Ah across every common lead-acid chemistry plus lithium.

Battery Chemistries
WETGELMF EFBAGMCALLithium (LiFePO4)
Works On
CarsTrucksBoats MotorcyclesATVs / UTVsPWCs TractorsMowers
Built To Be Left Alone

Safe inside and out.

Multiple layers of protection mean you can clip it on and walk away with confidence — and the rugged casing shrugs off a tough workshop or garage.

Reverse-polarity protection Short-circuit protection Spark-proof connection Over-voltage protection Overheat protection IP65 dust & water resistance Rugged ABS housing
Tech Specs

The numbers.

Charger Type
9-step smart charger
Battery Voltage
6V / 12V
Charging Current
Up to 6A (6V/3A · 12V/6A)
Charging Modes
12V/6A NORM·LI·Supply · 12V/3A Small · 12V/1A Repair · 6V/3A Norm
Input Voltage
100–240V AC, 50–60Hz
Power
81W max
Efficiency
Approx. 85%
Battery Chemistries
WET, GEL, MF, CAL, EFB, AGM, Lithium (LiFePO4)
Battery Capacity
5–240Ah
Back Current Drain
< 5mA
Working Temp
−10°C to 40°C
Storage Temp
−20°C to 75°C
Housing Protection
IP65
AC Cable Length
2 m
Clip Cord Length
1.8 m
Unit Dimensions
130 × 80 × 50 mm
Connectivity
Bluetooth · TOPDON BatteryLab app
In The Box

What you get.

TB6000 Pro Unit
The 2-in-1 charger and tester
Battery Clamps
Crocodile clip cord set
Ring Terminals
Permanent-mount eyelet leads
User Manual
Setup and operating guide

Covered by TOPDON's standard manufacturer warranty. Get in touch if you'd like the current warranty terms confirmed before you buy.

Questions

Frequently asked.

What batteries does it charge?
6V and 12V lead-acid batteries — including WET, GEL, MF, EFB, AGM and CAL types — plus 12V lithium, with a dedicated lithium charging mode. It handles capacities from 5Ah up to 240Ah.
Is it a charger or a tester?
Both. It charges through the patented 9-step cycle and also tests the battery's state of charge, state of health and CCA using the Kelvin method — so you can diagnose a battery and charge it with the one tool.
Do I need the app to use it?
No — it charges on its own. The free TOPDON BatteryLab app (iOS and Android) is optional and adds live monitoring, before/after reports, scheduled charging and expert-mode adjustments over Bluetooth.
Can I leave it connected long term?
Yes. After charging it switches to a maintenance float charge, making it ideal for keeping a classic, seasonal or weekend vehicle ready without overcharging. Built-in protections guard against reverse polarity, short circuits, over-voltage and overheating.
Can it recover a flat or sulfated battery?
In many cases, yes. The desulfation stage uses pulse-width modulation to break down sulfate build-up and restore internal resistance on ageing lead-acid batteries. The pre- and post-charge report shows how much the battery has improved.
How do I buy one and how is it delivered?
Use the Buy Now button to check out securely via Stripe. The price is $160 AUD including GST and shipping, and we post Australia-wide. If you have a question first, just get in touch.
Ready When You Are

Charge, test and revive — all in one.

The TOPDON TB6000 Pro is in stock and ships Australia-wide. Order securely online, or message us if you've got a question about your battery first.

$160.00 AUD · inc. GST + shipping